Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
Audi / A2 (8Z) / 03 - Brake electronics MK60 / Bleeding of the system
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
This operation was considered useful 3x.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- do preliminary deaeration in a standard manner
fit the deaeration jig to the brake fluid tank or ensure its continuous top-up for the duration of this test
connect with the control unit XX - Brake electronics
XX - Basic settings group XXX
activate default settings
observe values
field X, field X, field X, field X
follow the diagnostics instructions
(the following steps are next: wait XXs -> depress and hold - brake pedal -> release - brake pedal -> open RF + LF deaeration bolt -> XXx depress brake pedal -> fully close RF + LF deaeration bolt)
back
further, do:
Bleed the system in a conventional manner
after this operation, it is necessary to activate the function:
brake pressure sensor - Basic settings
- do preliminary deaeration in a standard manner
fit the deaeration jig to the brake fluid tank or ensure its continuous top-up for the duration of this test
connect with the control unit XX - Brake electronics
XX - Basic settings group XXX
activate default settings
observe values
field X, field X, field X, field X
follow the diagnostics instructions
(the following steps are next: wait XXs -> depress and hold - brake pedal -> release - brake pedal -> open RF + LF deaeration bolt -> XXx depress brake pedal -> fully close RF + LF deaeration bolt)
back
further, do:
Bleed the system in a conventional manner
after this operation, it is necessary to activate the function:
brake pressure sensor - Basic settings
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.