Audi / A3 (8L) / 03 - Brake electronics MK60 / Bleeding of the system

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in

Conditions:
- do preliminary deaeration in a standard manner

fit the deaeration jig to the brake fluid tank or ensure its continuous top-up for the duration of this test

connect with the control unit XX - Brake electronics

XX - Basic settings group XXX

activate default settings

observe values
field X, field X, field X, field X

follow the diagnostics instructions

(the following steps are next: wait XXs -> depress and hold - brake pedal -> release - brake pedal -> open RF + LF deaeration bolt -> XXx depress brake pedal -> fully close RF + LF deaeration bolt)

back

further, do:

Bleed the system in a conventional manner

after this operation, it is necessary to activate the function:

brake pressure sensor - Basic settings

Log-in