Audi / A3 (8P) / 03 - brake electronics / basic settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 2x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

connect with the control unit XX - Brake electronics

longitudinal acceleration sensor - switch-off

XX - Login
enter value: XXXXX
Start

XX - Basic settings group XXX
Start

system indicator light: ABS - blinks

longitudinal acceleration sensor is in state: OFF

Note:
- reactivated by switching the ignition off and on

steering wheel turn angle sensor (GXX) - settings

connect with the control unit XX - Brake electronics

XX - Login
enter value: XXXXX
Start

XX - Basic settings group XXX

drive the car over a short path with a maximum speed of XX km/h
sharply turn the steering wheel left and right in an angle of at least XX°, straighten the steering wheel and Stop the vehicle
do not move the steering wheel!

Start

XX - Measured values group XXX

required values:
field X = X,X° - + X,X°

drive the car over a short path with a maximum speed of XX km/h

end

transverse acceleration sensor - settings

XX - Login
enter value: XXXXX
Start

XX - Basic settings group XXX
Start

wait XXs

XX - Measured values group XXX
required values:
field X = -X,X° - + X.X°

end

brake fluid pressure sensor - settings

Conditions:
- brake pedal released

XX - Login
enter value: XXXXX
Start

XX - Basic settings group XXX
Start

wait XXs

XX - Measured values group XXX
required values:
field X = -X,X - + X,X

end

longitudinal acceleration sensor - settings

XX - Login
enter value: XXXXX
Start

XX - Basic settings group XXX
Start

wait XXs

XX - Measured values group XXX
required values:
field X = approx X

end

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy