Audi / A3 (8P) / 18 - auxiliary heater (Standheizer / Zuheizer) / Adaptation of remote control devices

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 2x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- PTC heater = OFF
- maximum number of controllers: X

connect with the control unit XX - Independent heater

XX - Measured values group XXX
required values
field X = OFF

XX - Basic settings group XXX
activate default settings

within X seconds press the OFF button on the remote control and hold for X second

required values
field X = learned

Log-in Buy