Audi / A3 (8P) / 44 - steering booster / Test of torque sensor (G269)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- ignition = ON
- engine speed = idling
- on-board voltage > XXV

connect with the control unit XX - engine

XX - Measured values group XXX
required values:
field X = terminal XX - ON (terminal - power supply)

if values are not achieved, check part: fuse, line

XX - Measured values group XXX

turn the steering wheel several time full way to the left and right

required values:
field X = control - torque - the value must change according to the actual condition

if values are not achieved, check part: steering torque sensor (GXXX), line

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy