Audi / A4 (8E) / 03 - Brake electronics Bosch 8.0 / basic settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

steering wheel turn angle sensor (GXX)

connect with the control unit XX - Brake electronics

XX - Measured values group XXX
observe values: field X (steering wheel turn angle sensor)

turn the steering wheel XX° left
turn the steering wheel - straight direction

required values:
field X = X,X° +- X°

XX - Login
enter value: XXXXX
Start

XX - Basic settings group XXX
Start

after stabilisation of values - continue

check of error memory
delete error memory

ESP unit (GXXX)

connect with the control unit XX - Brake electronics

XX - Login
enter value: XXXXX
Start

XX - Basic settings group XXX
Start

required values:
field X = OK

XX - Measured values group XXX
required values:
field X = ± X,XX m/sX

check of error memory
delete error memory

Created on: XX.XX.XXXX X:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy