Audi / A4 (8E) / 65 – tyre pressure monitoring (TPM) / Adaptation of pressure after replacement

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

X)
set the air pressure in the tyres according to the prescribed values for the given vehicle

X)
in the vehicle menu, select the item "tyre pressure"

X)
the display shows the message "system is learning!" This message goes off after several minutes of driving. In the process, it is necessary to drive at a minimum speed of X km/h, for about XX minutes. Interruption of smooth driving elongates the learning time

X)
as long as the display shows "system is learning!", tyre pressure check does issue any warning messages

X)
the message goes off after learning of the required pressure values

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy