Audi / A6 (4B) / OTHER PROCEDURES / Setting of steering angle sensor (G85)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in

turn the steering wheel - XX° left
turn the steering wheel - straight direction

connect with the control unit XX - Brake electronics

XX - Measured values group XXX
required values:
field X = X,X° - X,X° (steering wheel turn angle sensor)

XX - Login
enter value: according to the procedure in the Login section of this unit

XX - Basic settings group XXX
Start

wait XXs

check of error memory

end

Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in