Audi / A6 (4F) / OTHER PROCEDURES / Excitation of the hydraulic pump

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
- This function is used to bleed the hydraulic pump when changing brake fluid. It is necessary to use it when the pump was completely emptied. It is not necessary for normal work on the brakes including change of brake fluid, brake hoses or brake pads (linings). It also does not replace standard bleeding when one depresses the pedal and another releases the bleeding valves and captures the released brake fluid.

Conditions:
- lift the vehicle on a jack
- ignition = ON

connect with the control unit XX - Brake electronics

Golf, Golf GTI, Jetta, Audi TT

XX - Basic settings group XXX
Start
the pump is excited after: XXs

Passat, Audi AX/SX, AX/SX, AX/SX

XX - Basic settings group XXX
Start
the pump is excited after: XXs

Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy