Audi / A8 (4E) / 03 - brake electronics / coding

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in

Note
- Coding shall be accepted after Login.
- After successful coding, it is necessary to do basic setting of the steering angle sensor.

chassis:
X ? x x x

X = Audi S X (short wheelbase)
X = Audi AX (long wheelbase)
X = Audi AX (short wheelbase)

brakes:
X x ? x x

X = FNRG-XX XX" (PR-XLG)
X = XFNR XX AL XX" (PR-XLL)
X = XFNR XX AL XX" (PR-XLJ)
X = Brembo MX AL XX" (PR-XLW)

engine:
X x x ? x

X = XX cylinders - Petrol
X = XX cylinders - Petrol or X/X cylinders - Petrol/diesel s Brembo MX AL XX" (PR-XLW)
X = X/X cylinders - diesel, Brembo MX AL XX" (PR-XLW) NO
X = X cylinders - diesel (long wheelbase)
X = X/X cylinders - Petrol, Brembo MX AL XX" (PR-XLW) NO

gearbox:
X x x x ?

X = automatic transmission (XXE/XXL)
X = multitronic (XXJ)

Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in