Audi / Audi Q3 (F3) / 6C - Reverse camera [EV_CamSysRVRVCPANAMQBAB 006009] / Camera calibration

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- tailgate: closed
- Calibration equipment (VAS XXXX) , Measuring Laser (VAS XXXX/X) installed according to instructions
- Error memory empty except BXXXXXX - basic setting not done

connect with the control unit XC - reverse camera

Advanced Measured Values

select item in menu:

IDEXXXXX - system: status

TIP: For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

desired condition:
- passive
- passive - waiting
- active
- active - waiting
- OFF

continue

If the camera is mounted in rear logo:

XX - Actuators

select item in menu:

IDEXXXXX - reverse camera: engine

activate

measure the height from the floor to the camera = A [mm] (Note the measured value)
measure the distance of the calibration jig from the rear axle = B [mm] (Note the measured value)
measure the height of the calibration jig from the floor = C [mm] (Note the measured value)

XX - Basic settings

select item in menu:

IDEXXXXX-MASXXXXX - reverse camera system: calibration

Input the parameter:
A
B
C

activate default settings

wait XXs

desired condition: Successfully completed

End of test

Log-in Buy