Audi / Audi Q3 (F3) / 19 - Gateway [EV_GatewNF 013023] / Fatigue detection - settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
- adaptation is possible depending on the equipment

connect with the control unit XX - Gateway

status check

Advanced Measured Values

select item in menu:

IDEXXXXX-IDEXXXXX - recommended breaks: status - Defect
IDEXXXXX-MASXXXXX - recommended breaks: status - functions
IDEXXXXX-MASXXXXX - recommended breaks: system indicator light
IDEXXXXX-MASXXXXX - recommended breaks: system indicator light: deactivation

TIP: For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

settings

adaptation

select item in menu: IDEXXXXX - MKE CheckBox

TIP: For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

enter value:
active = fatigue detection: active
inactive = fatigue detection: inactive

Test
Save

switch ignition off for XXs

Log-in Buy