Audi / Audi Q5 (FY) / 19 - Gateway [EV_Gatew31xAU65x 003291] / Disconnect after impact - unblocking

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
•         This procedure may require the roof to be opened or the SFD protection to be unlocked
•         This procedure may require temporary deactivation of the Gateway diagnostic filter

This is the procedure for unlocking the following control unit after impact: XX - Gateway

The procedure for unlocking after impact must be performed in the following order on the following control units:

•         XX - engine
•         XX - Electric drive
•         XXXX - DC Convertor
•         XC - HV Battery
•         CX - Battery charger
•         XX - Gateway

Go to the respective control units in VIS for the specific procedures

Only persons with the appropriate qualifications may work on repairs to vehicles with a high-voltage system! The author of this procedure explicitly prohibits use of this information and performance of this procedure if you do not have the appropriate qualifications!!!

connect with the control unit XX - Gateway

Unlock SFD

XX - Basic settings UDS
select item in menu:
IDEXXXXX - Disconnect after impact - reset
Start
desired condition: Successfully completed

delete error memory

switch ignition off for XXs

do a test drive >Xkm

End of test

Created on: X.X.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
Special thanks to Josef Haptman

Log-in Buy