Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator- Scan Explorer
Audi / Audi R8 (FX) / 6C - Reverse camera [EV_CamSysRearPANAAU914 002002] / Camera calibration
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- tailgate: closed
- Calibration equipment (VAS XXXX) , Measuring Laser (VAS XXXX/X) installed according to instructions
- Error memory empty except BXXXXXX - basic setting not done
connect with the control unit XC - reverse camera
Advanced Measured Values
select item in menu:
IDEXXXXX - system: status
TIP: For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window
desired condition:
- passive
- passive - waiting
- active
- active - waiting
- OFF
continue
If the camera is mounted in rear logo:
XX - Actuators
select item in menu:
IDEXXXXX - reverse camera: engine
activate
measure the height from the floor to the camera = A [mm] (Note the measured value)
measure the distance of the calibration jig from the rear axle = B [mm] (Note the measured value)
measure the height of the calibration jig from the floor = C [mm] (Note the measured value)
XX - Basic settings
select item in menu:
IDEXXXXX-MASXXXXX - reverse camera system: calibration
Input the parameter:
A
B
C
activate default settings
wait XXs
desired condition: Successfully completed
End of test
- tailgate: closed
- Calibration equipment (VAS XXXX) , Measuring Laser (VAS XXXX/X) installed according to instructions
- Error memory empty except BXXXXXX - basic setting not done
connect with the control unit XC - reverse camera
Advanced Measured Values
select item in menu:
IDEXXXXX - system: status
TIP: For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window
desired condition:
- passive
- passive - waiting
- active
- active - waiting
- OFF
continue
If the camera is mounted in rear logo:
XX - Actuators
select item in menu:
IDEXXXXX - reverse camera: engine
activate
measure the height from the floor to the camera = A [mm] (Note the measured value)
measure the distance of the calibration jig from the rear axle = B [mm] (Note the measured value)
measure the height of the calibration jig from the floor = C [mm] (Note the measured value)
XX - Basic settings
select item in menu:
IDEXXXXX-MASXXXXX - reverse camera system: calibration
Input the parameter:
A
B
C
activate default settings
wait XXs
desired condition: Successfully completed
End of test
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
