Audi / Q2 (GA) / 03 - Brake electronics MK100 IPB ESC [EV_Brake1UDSContiMK100IPB 049012] / Bleeding of the system

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 4x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- do preliminary deaeration in a standard manner
- Connect the bleeding jig VASXXXX
- connect battery charger

connect with the control unit XX - Brake electronics

Deaeration jig -> OFF

XX - Basic settings

select item in drop-down menu: IDEXXXXX Bleeding of the brakes

In the parameter menu, select: X. Flushing cycle

Start

X x fully depress - brake pedal
release - brake pedal
open LF deaeration bolt
Deaeration jig -> ON

Stop

XX - Basic settings

select item in drop-down menu: IDEXXXXX Bleeding of the brakes

In the parameter menu, select: Bleeding of the brakes - front axle

Start

X x fully depress - brake pedal
release - brake pedal
fully close - LF deaeration bolt
open RF deaeration bolt

Stop

XX - Basic settings

select item in drop-down menu: IDEXXXXX Bleeding of the brakes

In the parameter menu, select: Bleeding of the brakes - rear axle

Start

X x fully depress - brake pedal
release - brake pedal
fully close - RF deaeration bolt
Deaeration jig > OFF

Stop

XX - Basic settings

select item in drop-down menu: IDEXXXXX Bleeding of the brakes

In the parameter menu, select: X. Flushing cycle

Start

X x fully depress - brake pedal
release - brake pedal
open - RR deaeration bolt
Deaeration jig > ON

Stop

XX - Basic settings

select item in drop-down menu: IDEXXXXX Bleeding of the brakes

In the parameter menu, select: Bleeding of the brakes - front axle

Start

X x fully depress - brake pedal
release - brake pedal
fully close - RR deaeration bolt
open - LR deaeration bolt

Stop

XX - Basic settings

select item in drop-down menu: IDEXXXXX Bleeding of the brakes

In the parameter menu, select: Bleeding of the brakes - rear axle

Start

X x fully depress - brake pedal
release - brake pedal
fully close - LR deaeration bolt
Deaeration jig > OFF

Stop

XX - Basic settings

select item in drop-down menu: IDEXXXXX Bleeding of the brakes

In the parameter menu, select: Bleeding of the brakes - X. Flushing cycle

Start

X x fully depress - brake pedal

Stop

open - RR deaeration bolt
Deaeration jig > ON
fully depress - brake pedal
continue as soon as clean air-bubble free brake fluid starts flowing
fully close - RR deaeration bolt

open - LR deaeration bolt
fully depress - brake pedal
continue as soon as clean air-bubble free brake fluid starts flowing
fully close - LR deaeration bolt
Deaeration jig > OFF

further, do:

- Bleed the system in a conventional manner

Log-in Buy