Audi / Q3 (8U) / 44 - steering booster 3. of generation (EPS_ZFLS Kl.x / J500__APA-BS KL) CAN / dynamic chassis control (DCC) - settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
- adaptation is possible depending on the equipment
- done after replacement of component - steering booster

- The DCC system through the adaptive shock absorbers controls the riding characteristics of the vehicle

connect with the control unit XX - Power steering

XX - Adaptation channel XXX
enter value:

X = dynamic chassis control (DCC) (PR-XHX) - not installed
X = dynamic chassis control (DCC) (PR-HX) - installed

Test
Save

switch ignition off for XXs

Log-in Buy