Audi / Q7 (4L) / 19 - Gateway (J533 Gateway) CAN / fatigue detection - settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
- adaptation is possible depending on the equipment

connect with the control unit XX - Gateway

XX - Measured values group XXX
observe values - field X
XXXXX = fatigue detection = active
XXXXX = fatigue detection = inactive

XA - Adaptation II channel XX

enter value:
XXXXX = fatigue detection: active

Test
Save

switch ignition off for XXs

Log-in Buy