Audi / Q7 (4L) / 34 - clearance height control / Setting of the zero point of the height adjustment system

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 4x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- gear engaged (P)
- engine speed = idling

basic value
Touareg (XL) - in front = XXX mm, in rear = XXX mm
Touareg (XL) - offroad = XXX mm, in rear = XXX mm

AX (XE) - in front = XXX mm, in rear = XXX mm
AX (XE) - sports chassis - in front = XXX mm, in rear = XXX mm

Phaeton - in front = XXX mm, in rear = XXX mm

Audi QX (XL) - in front = XXX mm, in rear = XXX mm

Audi AX (XF) - in front = XXX mm, in rear = XXX mm
Audi AX (XF) Allroad - in front = XXX mm, in rear = XXX mm

connect with the control unit XX - clearance height control

XX - Login (XX - Security access)

enter value XXXXX

Start

XX - Adaptation channel XXX (LF wheel)

measure the distance from the wheel centre to the edge of the fender (lowest point on the outer side) and enter this value in mm as a new value

Test
Save

XX - Adaptation channel XXX (RF wheel)

measure the distance from the wheel centre to the edge of the fender (lowest point on the outer side) and enter this value in mm as a new value

Test
Save

XX - Adaptation channel XXX (LR wheel)

measure the distance from the wheel centre to the edge of the fender (lowest point on the outer side) and enter this value in mm as a new value

Test
Save

XX - Adaptation channel XXX (RR wheel)

measure the distance from the wheel centre to the edge of the fender (lowest point on the outer side) and enter this value in mm as a new value

Test
Save

XX - Adaptation channel XXX

enter value: X

Test
Save

Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy