Audi / Q7 (4M) / 13 - Adaptive distance control [EV_ACCBOSCHAU736 002018] / Adaptive distance control - setting


Mark Model Control unit Diagnostic operation
Displayed 1-20 records out of 100. << < 1 > >>
Mark
Model
Control unit
Diagnostic operation
Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and  You will get login to diagnostic procedures database imediatelly.

Volkswagen workshop manuals for diagnostics

Log-in Buy

Note:
done after repair of components:
•         test / wheel alignment
•        
front cross-member
•        
distance control - control unit

Conditions:
•         locate the vehicle on a device for measurement and setting of the wheel alignment
•         install calibration jig: VAS XXXX or VAS XXXX or calibration plate
•        
distance calibration plate - logo Audi = XXXcm+-X,X cm
•         You can find more important information about this procedure in the erWin servicing manual

X) control unit JXXX (
right side)


connect with the control unit
XX - adaptive distance control


XX - Actuators

select item in menu:

IDEXXXXX - calibration

In the Actuators window, click Measured values and select the items you want to visualize.

IDEXXXXX -
calibration - instructions

Adjust mirror to position
X

XX - Actuators -> Start

follow the diagnostics instructions

required value: calibration OK

back

Advanced Measured Values

TIP:
For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

select item in menu:
IDEXXXXX-MASXXXXX - settings up left - direction
IDEXXXXX-MASXXXXX - settings up left - rotation

IDEXXXXX-MASXXXXX - settings up right side - direction
IDEXXXXX-MASXXXXX - settings up right side - rotation

Adjust bolts according to description. If the bolts are moved, the previous steps must be repeated until the unit is adjusted properly.



X) control unit JXXX (left)

connect with the control unit XB - adaptive distance control II



XX - Actuators

select item in menu:

IDEXXXXX - calibration

In the Actuators window, click Measured values and select the items you want to visualize.

IDEXXXXX -
calibration - instructions

Adjust mirror to position
X

XX - Actuators -> Start

follow the diagnostics instructions

required value: calibration OK

back

Advanced Measured Values

TIP:
For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

select item in menu:
IDEXXXXX-MASXXXXX - settings up left - direction
IDEXXXXX-MASXXXXX - settings up left - rotation

IDEXXXXX-MASXXXXX - settings up right side - direction
IDEXXXXX-MASXXXXX - settings up right side - rotation

Adjust bolts according to description. If the bolts are moved, the previous steps must be repeated until the unit is adjusted properly.


End of test


This procedure was generated by robot VISHunter XXXXXX X.X.XXXX at XX:XX:XX on ACS-NTB



You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and  You will get login to diagnostic procedures database imediatelly.

Volkswagen workshop manuals for diagnostics

Log-in Buy