Audi / R8 (42) / 65 – tyre pressure monitoring (TPM) / Special procedure

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Check the tyre pressure, eventually inflate to correct pressure. Then re-code the TPMS. Probably, the same coding values already stored will be suitable. But if you have doubts, slightly increase the lower specified pressure values. Then re-adjust these values to initial values. After re-coding the module, it is always necessary to drive the vehicle continuously for XX minutes at a speed above XX km/h

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy