Audi / TT (8J) / 03 - Brake electronics MK60 / Driving test

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- system indicator light: ABS (KXX) - on
- system indicator light: ASR (KXXX) - off
- engine speed = X rpm
- vehicle at idle

Note:
- the ESP drive test is used to check the reliability of the signals from the lateral acceleration sensor, rotation speed and pressure sensor
- this test must also be done always upon disassembly, or replacement of ESP system components
- as soon as the ESP road starts, it is not possible to cancel it. The entire procedure must run
- the period from Basic Settings to Start of driving should not exceed X minute
- during test drive, ABS/EDS/ASR/ESP must not be activated
- second mechanic necessary

- observe the occupation safety rules when taking a test drive with connected diagnostics tester

connect with the control unit XX - Brake electronics

XX - Security access / XX - Coding II

enter value: XXXXX

Start

XX - Basic settings group XXX
Start

wait Xs

XX - end of communication

disconnect - diagnostic cable

Start the engine

depress brake pedal

for MY XXXX and later, the brake pedal MUST NOT BE depressed to activate the driving test

desired condition:
brake fluid pressure > XX bar (MY - XXXX)
system indicator light: ASR (KXXX) - on

sharply turn left and then right at a minimum angular speed of XX°/s (turning radius XX - XXm speed XX- XX km/h)

desired condition:
system indicator light: ABS (KXX) - off

end

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy