Engines / Diesel / 1.9/74kW TDI-PD BMT / creation of Readiness (200)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 2x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- engine temperature > XX°C
- engine speed = X rpm - X minutes
- ignition = OFF - X minutes
- speed = X km/h
- parking brake - ON
- gear engaged (P)
- exhaust system - tightness = OK
- residual fuel volume in tank = MIN X/X
- intake air temperature < XX °C
- brake pedal - switch = OK

The Readiness Code must be created as the last diagnostics task. Later deletion of the memory could also result in deletion of the created Readiness Code.

connect with the control unit XX - engine

delete error memory

switch-off the ignition

wait XX s

Start the engine

engine speed = idling

XX - Basic settings group XXX

activate default settings

follow the diagnostics instructions

may take several minutes

required values:
field X = Syst-OK

if values are not achieved - check of error memory

XX - end of communication

Log-in Buy