Engines / Diesel / 1.9/77kW TDI-PD BLS; BVB; BXJ; BSU / additive injection system - bleeding (deaeration)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- engine speed = idling
- if the fuel level is above X/X tank, it is necessary to repeat this procedure twice !!!

Note:
done after replacement of component:
- fuel tank
- additive pump
- additive tank

done after repair of components
- additive injection system

Start the engine

connect with the control unit XX - engine

XX - Coding II

enter value XXXXX

Start

XX - Measured values group XXX

wait

required values
field X = X

XX - end of communication

Log-in Buy