Engines / Diesel / 2.0/100/103kW TDI-PD BLB;BNA;BRE;BRF;BVF;BVG / creation of Readiness

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- number of faults = X
- engine temperature >= XX°C

connect with the control unit XX - engine

XX - Measured values group XXX
required values:
field X >= XX°C

switch ignition off for: Xs

switch on the ignition

wait XXs

XX - Actuators
select item - glowing
Start

wait XXs

back

Start the engine

increase rpm to XXXX - XXXX rpm

XX - Measured values group XXX
required values:
field X = XXXX - XXXX rpm

XX - Measured values group XXX
required values:
field X >= XX% (heating of lambda probe(s)

if values are not achieved - increase rpm to XXXX - XXXX rpm

wait

required values:
field X >= XX% (heating of lambda probe(s))

check of error memory

XX - Measured values group XXX
required values:
field X = XXX
field X = XXX

if values are not achieved - execute function: Creation of readiness

Log-in Buy