Engines / Diesel / 2.0/103kW TDI-CR CBAx / Test of filling pressure
Mark | Model | Control unit | Diagnostic operation |
---|
Mark
Model
Control unit
Diagnostic operation
Diagnostic procedure
This operation was considered useful 2x.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- air filter - clean
Note:
- observe the occupation safety rules when taking a test drive with connected diagnostics tester
connect with the control unit XX - engine
XX - Measured values group XXX
engine speed = idling
observe values: field X, field X
required values:
field X = XXX - XXXX mbar (actual value -atmospheric pressure)
field X = XXX - XXXX mbar (actual value filling pressure)
from XXXX rpm, accelerate in Xrd gear to about XXXX rpm - full load
required values:
field X = XXX - XXXX mbar (actual value -atmospheric pressure)
field X = XXXX - XXXX mbar (actual value filling pressure)
if values are not achieved - field X - check component:
- atmospheric pressure sensor
if values are not achieved - field X - check component:
- turbo blower
- filling pressure sensor
- tightness of line
- air filter - clean
Note:
- observe the occupation safety rules when taking a test drive with connected diagnostics tester
connect with the control unit XX - engine
XX - Measured values group XXX
engine speed = idling
observe values: field X, field X
required values:
field X = XXX - XXXX mbar (actual value -atmospheric pressure)
field X = XXX - XXXX mbar (actual value filling pressure)
from XXXX rpm, accelerate in Xrd gear to about XXXX rpm - full load
required values:
field X = XXX - XXXX mbar (actual value -atmospheric pressure)
field X = XXXX - XXXX mbar (actual value filling pressure)
if values are not achieved - field X - check component:
- atmospheric pressure sensor
if values are not achieved - field X - check component:
- turbo blower
- filling pressure sensor
- tightness of line
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.