Engines / Diesel / 2.0/103kW TDI-PD BPW;BRC / Test of cruise control

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- on-board voltage > XXV
- cruise control - activated

connect with the control unit XX - engine

cruise control - status - Test

XX - Measured values group XXX
required values: field X
xxxxXxxx = CCS permitted
xxxXxxxx = ACC permitted
XXxxxxxx = ACC/GRA activated
XXxxxxxx = ACC blocked

if values are not achieved - check component: cruise control, line CAN-Bus

cruise control button - Test

XX - Measured values group XXX
required values: field X
xxxxxxxX = pressed - ON
xxxxxxXx = pressed - OFF
xxxxxXxx = pressed - deceleration (-)
xxxxXxxx = pressed - akceleraion (+)
xxxXxxxx = pressed - set
xxXxxxxx = pressed - reset

if values are not achieved - check component: cruise control, line CAN-Bus

Log-in Buy