Engines / Diesel / 2.5/110kW TDI AFB; AKN / Test of air mass sensor
Mark | Model | Control unit | Diagnostic operation |
---|
Mark
![Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.](/admin_assets/images/silk/comment.png)
Model
![Select a vehicle model or information group, for example Octavia III or Diesel, Petrol etc.](/admin_assets/images/silk/comment.png)
Control unit ![Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.](/admin_assets/images/silk/comment.png)
![Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.](/admin_assets/images/silk/comment.png)
Diagnostic operation ![Select the desired diagnostic procedure.](/admin_assets/images/silk/comment.png)
![Select the desired diagnostic procedure.](/admin_assets/images/silk/comment.png)
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- engine speed = idling
- second mechanic necessary!
connect with the control unit XX - engine
XX - Measured values group XXX
required values:
field X = engine AFB = XXX mg/H, engine AKN = XXX-XXXmg/H
field X = X%
if values are not achieved, check part: exhaust recirculation
upon achievement of values - continue
do a test drive
from XXXX rpm, accelerate in Xrd gear to about XXXX rpm
XX - Measured values group XXX
required values:
field X > XXX mg/H
field X = XXXX-XXXX mbar
field X = XXX%
end
Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
- engine speed = idling
- second mechanic necessary!
connect with the control unit XX - engine
XX - Measured values group XXX
required values:
field X = engine AFB = XXX mg/H, engine AKN = XXX-XXXmg/H
field X = X%
if values are not achieved, check part: exhaust recirculation
upon achievement of values - continue
do a test drive
from XXXX rpm, accelerate in Xrd gear to about XXXX rpm
XX - Measured values group XXX
required values:
field X > XXX mg/H
field X = XXXX-XXXX mbar
field X = XXX%
end
Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.