Engines / Diesel / 3.0 TDI CR / flap in intake manifold - cylinder row 1 - basic settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- engine temperature > XX°C
- number of faults = X

connect with the control unit XX - engine

switch-off the ignition

Start the engine

flap in intake manifold - cylinder row X - basic settings

XX - Basic settings group XXX
Start

depress and hold - brake pedal

depress and hold - clutch pedal

the control unit increases the engine speed - XXXX rpm

the flaps in the intake manifold now open and close in time intervals

required values - flap in intake manifold - open
field X = XXXX - XXXX rpm (engine speed)
field X = X - X % (flap in intake manifold - cylinder row X)

required values - flap in intake manifold - closed
field X = XXXX - XXXX rpm (engine speed)
field X = XX - XX % (flap in intake manifold - cylinder row X)

wait XX s

Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy