Engines / Diesel / Continental SIMOS PCR 2.1 Continental CAYx UDS general / Test of air mass sensor (G70)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- air filter = clean
- intake system - tightness of line
- engine speed - idling
- coolant temperature > XX°C

Note:
- observe the occupation safety rules when taking a test drive with connected diagnostics tester

connect with the control unit XX - engine

Advanced Measured Values

select item in menu: IDEXXXXX-ENGXXXXXX - Air mass - actual value (mg/stroke)-MAF_MES

TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

required value:

XXX - XXX mg/inject. (actual value - Air mass)

from XXXX rpm, accelerate in Xrd gear to about XXXX rpm - full load

required value:

XXX - XXXX mg/inject. (actual value - Air mass)

if values are not achieved - check component:

- Intake air mass sensor
- tightness of line
- filling pressure

Log-in Buy