Engines / Diesel / EDC 15 general / Cruise control - test 2

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- engine speed = idling

connect with the control unit XX - engine

XX - Measured values group XXX
observe values: field X
XXXX = cruise control - deactivated
XXXX = cruise control - activated

observe values: field X
XXXX = cruise control switch - OFF
XXXX = cruise control switch - ON
XXXX = cruise control switch - RES
XXXX = cruise control button - pressed (cruise control switch - ON)

if values are not achieved
check component: cruise control device, line CAN-Bus - cruise control device -> engine control unit

Note:
- the cruise control can be activated from a speed of XX km/h

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy