Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
Engines / Diesel / EDC 16 general / Adjustment of the starting fuel dose for EDC16 units
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Note:
In some diesel engines, the difficult hot engine Start fault appears after a longer period. This is usually caused either by a weak battery, higher resistance of the power supply cable to the starter whereby there is high residual voltage in the cable and the starter thus does not have the high speed that it should have, or the starter itself is faulty. In such case the engine does not have adequate speed and the control unit fails to calculate the correct starting fuel dose. This phenomenon does not appear in cold starts because the nit enriches the fuel mixture for cold starts in the same manner applies to the choke on old engines. The recommended repair procedure is replacement of the entire faulty parts (battery, power cable, starter). A completely wrong common car repair practice is increase of the starting fuel dose by adjustment of the values in the control unit. This eliminates only the symptom of the fault but not its cause. Moreover, it is only a temporary solution, the battery/cable/starter shall deteriorate in time until complete failure.
connect with the control unit XX - engine
XX - Login
enter value: XXXXX
Start
XX - Adaptation channel XX
basic value = X
enter value: X
Test
Save
switch ignition off for: XXX s
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
In some diesel engines, the difficult hot engine Start fault appears after a longer period. This is usually caused either by a weak battery, higher resistance of the power supply cable to the starter whereby there is high residual voltage in the cable and the starter thus does not have the high speed that it should have, or the starter itself is faulty. In such case the engine does not have adequate speed and the control unit fails to calculate the correct starting fuel dose. This phenomenon does not appear in cold starts because the nit enriches the fuel mixture for cold starts in the same manner applies to the choke on old engines. The recommended repair procedure is replacement of the entire faulty parts (battery, power cable, starter). A completely wrong common car repair practice is increase of the starting fuel dose by adjustment of the values in the control unit. This eliminates only the symptom of the fault but not its cause. Moreover, it is only a temporary solution, the battery/cable/starter shall deteriorate in time until complete failure.
connect with the control unit XX - engine
XX - Login
enter value: XXXXX
Start
XX - Adaptation channel XX
basic value = X
enter value: X
Test
Save
switch ignition off for: XXX s
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.