Engines / Diesel / EDC 17 CAN general / Check of clogging level of Diesel particulate filter CR

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
- if filter clogging is more than XXg, it is necessary to replace it

connect with the control unit XX - engine

XX - Measured values group XXX group XXX or XXX

observe values: group XX
field X = temperature upstream of component: turbo blower
field X = temperature upstream of component: Diesel Particulate Filter
field X = temperature downstream of component: Diesel Particulate Filter

observe values: group XXX
field X = clogging of Diesel particulate filter (calculated value)
field X = clogging of Diesel particulate filter (actual value)

observe values: group XXX
field X = clogging of Diesel particulate filter (calculated value)
field X = clogging of Diesel particulate filter (actual value)

End of test

Log-in Buy