Engines / Diesel / EDC 17 CAN general / Test - filling pressure controller - turbo blade geometry sensor

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

connect with the control unit XX - engine

XX - Measured values group XXX

engine speed = X rpm

required values
field X = X,X - X,X V

engine speed =idling

required values
field X = X,XX - X,XX V

if values are not achieved - check component:
- Charge Pressure Controller - tightness
- electromagnetic valve for control of filling pressure (NXX)
- line: electromagnetic valve for control of filling pressure -> Charge Pressure Controller - tightness
- settings - Charge Pressure Controller - turbo blade geometry sensor

Log-in Buy