Engines / Diesel / EDC 17 UDS general / Check of clogging level of Diesel particulate filter

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 2x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
• If the filter is clogged above the maximum value, it is necessary to replace it with a new.

connect with the control unit XX - engine

Advanced Measured Values

select item in menu:

IDEXXXXX - Diesel Particulate Filter - clogging of Diesel particulate filter - oil ash
IDEXXXXX - Diesel Particulate Filter - clogging of Diesel particulate filter - oil ash - Maximum value

TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

desired condition

IDEXXXXX < IDEXXXXX

Note:
• after replacement of DPF, it is necessary to zero the clogging value in the control unit

Log-in Buy