Engines / Diesel / EDC 17 UDS general / Test of gas pedal position sensor 1;2 (G79); (G185)


Mark Model Control unit Diagnostic operation
Displayed 1-20 records out of 100. << < 1 > >>
Mark
Model
Control unit
Diagnostic operation
Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and  You will get login to diagnostic procedures database imediatelly.

Volkswagen workshop manuals for diagnostics

Log-in Buy

Conditions:
- engine speed = X rpm


connect with the control unit XX - engine

Advanced Measured Values

select item in menu:

IDEXXXXX -
accelerator pedal - Position sensor X: voltage
IDEXXXXX - accelerator pedal - Position sensor X: voltage
IDEXXXXX-ENGXXXXXX - idle speed switch: status
IDEXXXXX - accelerator pedal - position


TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

Start


alternately operate the accelerator pedal


required values

X)

desired condition:

X x [IDEXXXXX] = [IDEXXXXX] ± X%

for instance:
IDEXXXXX = XX%
IDEXXXXX = XX%
X x XX = XX -> OK

TIP: for this test, it is suitable to use graphical representation


Picture documentation




X)
IDE-XXXXX-ENGXXXXXX =
XXXXXXXX (Xhex | Xdec)
= idle speed switch - on
XXXXXXXX (XXhex | XXdec)
= kick-down
XXXXXXXX (XXhex | XXdec)
= Higher idle run

X)
IDEXXXXX = X - XXX%



if values are not achieved, check part:
- accelerator pedal: Position sensor (GXX)
- accelerator pedal: Position sensor (GXXX)
- accelerator pedal: control line



End of test


You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and  You will get login to diagnostic procedures database imediatelly.

Volkswagen workshop manuals for diagnostics

Log-in Buy