Engines / Petrol / 1.2-1.4/63-110kW TSI CJZx/CMBx/CXSx/CPTx/CRJx/CNLx/CSTx (UDS) / Test: ignition coil (N70; N71; N72; N73; N292)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
•         ignition = OFF
•         on-board voltage > XX
•         engine speed = X rpm

disconnect from power supply part: ignition coil

measure resistance between terminals:
X (connector - component side)
X (connector - component side)

required value = XXX - XXX Ohm

Conditions:
- ignition = ON

measure voltage between terminals:
X (connector - control unit side)
ground

required value = > XXV

measure voltage between terminals:
X (connector - control unit side)
X (connector - control unit side)

required value = > XXV

measure voltage between terminals:
X (connector - control unit side)
X (connector - control unit side)

required value = > XXV

upon non--achievement of condition - check component:
- wiring: engine control unit -> ignition coil
- engine control unit

Log-in Buy