Engines / Petrol / 1.2/63kW TFSI CBZA (UDS) / Default throttle valve settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in

Note:
done after repair of components: throttle valve
done after replacement of component: throttle valve, engine - control unit

Conditions:
- on-board voltage > XX V (Advanced Measured Values IDEXXXXX)
- intake air temperature > XX °C (Advanced Measured Values IDEXXXXX)
- engine temperature >= XX °C (Advanced Measured Values IDEXXXXX)
- engine speed = X rpm
- accelerator pedal = released (Advanced Measured Values IDEXXXXX-ENGXXXXXX)

TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

connect with the control unit XX - engine

XX - Basic settings

select item in menu: IDEXXXXX - throttle valve - adaptation - Test

Start

follow the diagnostics instructions

desired condition: Successfully completed

XX - Basic settings - Stop

end

switch ignition off for XX s

Log-in