Engines / Petrol / 1.6/85kW FSI BAG/BLF/BLP / basic settings - fuel pump

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- on-board voltage >= XXV (XX - Measured values group XXX field X)

Erasing of learning values

Note:
- if the adaptation values have already been deleted at this stage, then do not redo this adaptation value deletion process to prevent deletion of already adapted components
- if the adaptation values are now deleted, it is necessary to do basic setting (adaptation) of ALL subordinate actuators that require this, e.g. EGR, EVAP, throttle valve, etc.

disconnect from power supply part - engine control unit

wait XX MIN

connect - engine control unit

Basic settings

Start the engine - engine speed = idling

connect with the control unit XX - engine

XX - Basic settings group XXX
activate default settings

required values
field X = ADP-OK (may take several minutes)

XX - end of communication

switch ignition off for XX s

Log-in Buy