Engines / Petrol / 1.8/132 kW AUQ / Adaptation after replacement of engine control unit gen. 3 - new unit


Mark Model Control unit Diagnostic operation
Displayed 1-20 records out of 100. << < 1 > >>
Mark
Model
Control unit
Diagnostic operation
Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and  You will get login to diagnostic procedures database imediatelly.

Volkswagen workshop manuals for diagnostics

Log-in

Conditions:
- install component: engine control unit
- before this operation, take down the identification and coding of the initial control unit

connect with the control unit XX - engine

XX - Adaptation channel XX
enter value: Vehicle PIN
for instance XXXX enter as XXXXX
Test
Save

immobiliser indicator light: off

check of error memory

Note:
- If this procedure is not done properly, the immobilizer blocks for XX minutes; it is necessary to switch-off the ignition and wait.
- The newly installed and adapted control unit has adopted the VIN, SKZ and PIN and shall continue to use initial PIN of the vehicle


Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and  You will get login to diagnostic procedures database imediatelly.

Volkswagen workshop manuals for diagnostics

Log-in