Engines / Petrol / 2.0/110kW FSI AWA / Test of gas pedal position sensor

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- engine speed = X

connect with the control unit XX - engine

accelerator pedal - released

XX - Measured values group XXX
required values
field X = X% - XX% (gas pedal position sensor X (GXX))
field X = X% - X% (gas pedal position sensor X (GXXX))

desired condition: field X = field X * X (±X%)

fully depress accelerator pedal

(values must rise smoothly, it is recommended to use a graphics display for this function)

required values
field X = X% - XXX% (gas pedal position sensor X)
field X = X% - XX% (gas pedal position sensor X)

desired condition: field X = field X * X (±X%)

XX - end of communication

if values are not achieved - check component:
- gas pedal position sensor
- line

Log-in Buy