Engines / Petrol / COMMON PROCEDURES / Setting of EGR

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- ignition = ON
- engine speed = X
- on-board voltage > XX,X V
- engine control unit MEX.X - engine temperature - XX°C - XX°C

connect with the control unit XX - engine

XX - Measured values group XXX

required values:
field X = minimum position - voltage
field X = maximum position - voltage
field X = potentiometer for the adjuster - voltage
field X = Basic settings - status

switch to function: XX - Basic settings

required values:
field X = ADP-OK

switch to function: XX - Measured values

XX - end of communication

Note:
- if the function fails, SWITCH-OFF the ignition for XX seconds and then SWITCH-ON the ignition and retry

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy