Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
Engines / Petrol / COMMON PROCEDURES / Setting of throttle valve
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
This operation was considered useful 2x.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- number of faults = X
- on-board voltage > XX,XV
- accelerator pedal - released
- engine temperature = X°C - XX°C
- ignition = ON
- engine speed = X
throttle valve controlled by wire
connect with the control unit XX - engine
XX - Measured values group XXX (engine control unit SIMOS, Magneti Marelli group XXX)
switch to function: XX - Basic settings
required values:
field X = ADP-RUN
wait XXs
required values:
field X = ADP-OK
switch to function: XX - Measured values
throttle valve controlled by bus (KWXXXX)
connect with the control unit XX - engine
XX - Measured values group XXX
switch to function: XX - Basic settings
required values:
field X = ADP-RUN
wait XXs
required values:
field X = ADP-OK
switch to function: XX - Measured values
throttle valve controlled by bus (KWXXXX / CAN)
connect with the control unit XX - engine
XX - Measured values group XXX
switch to function: XX - Basic settings
OFF/ON/next
required values:
field X = ADP-RUN
wait XXs
required values:
field X = ADP-OK
OFF/ON/next
XX - end of communication
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
- number of faults = X
- on-board voltage > XX,XV
- accelerator pedal - released
- engine temperature = X°C - XX°C
- ignition = ON
- engine speed = X
throttle valve controlled by wire
connect with the control unit XX - engine
XX - Measured values group XXX (engine control unit SIMOS, Magneti Marelli group XXX)
switch to function: XX - Basic settings
required values:
field X = ADP-RUN
wait XXs
required values:
field X = ADP-OK
switch to function: XX - Measured values
throttle valve controlled by bus (KWXXXX)
connect with the control unit XX - engine
XX - Measured values group XXX
switch to function: XX - Basic settings
required values:
field X = ADP-RUN
wait XXs
required values:
field X = ADP-OK
switch to function: XX - Measured values
throttle valve controlled by bus (KWXXXX / CAN)
connect with the control unit XX - engine
XX - Measured values group XXX
switch to function: XX - Basic settings
OFF/ON/next
required values:
field X = ADP-RUN
wait XXs
required values:
field X = ADP-OK
OFF/ON/next
XX - end of communication
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.