Engines / Petrol / ME 7.5.20 general / creation of Readiness (207)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in

Conditions:
- number of faults = X
- engine temperature > XX°C (XX - Measured values group XXX field X)
- intake air temperature > X°C (XX - Measured values group XXX field X)
- catalyst temperature > XXX °C (XX - Measured values group XXX field X)
- on-board voltage > XXV (XX - Measured values group XXX field X)
- engine speed = X
- accelerator pedal - released (XX - Measured values group XXX field X)

Note:
The readiness Code must be created as the last diagnostics task. Later deletion of the memory could also result in deletion of the created readiness Code.

Start the engine, engine speed = idling

wait XXX s

switch on the ignition

connect with the control unit XX - engine

XX - Basic settings group XXX
activate default settings

wait

required values
field X = ADP-OK (may take several minutes)

upon achievement of values - continue

Start the engine, engine speed = idling

XX - Measured values group XXX
required values
field X = XXXXXXXX
field X = XXXXXXXX
may take several minutes

upon achievement of values - continue

XX - Basic settings group XXX
activate default settings

fully depress - brake pedal + accelerator pedal

required values
field X = XXXXXXXX

upon achievement of values - continue

release - brake pedal + accelerator pedal

Conditions:
- high beam = ON
- air-conditioning = ON
- rear window heating = ON

XX - Basic settings group XXX
activate default settings

fully depress - brake pedal + accelerator pedal

required values
field X = BX-SX OK

upon achievement of values - continue

release - brake pedal + accelerator pedal

XX - Basic settings group XXX
activate default settings

fully depress - brake pedal + accelerator pedal

required values
field X = BX-SX OK

upon achievement of values - continue

release - brake pedal + accelerator pedal

Conditions:
- high beam = OFF
- air-conditioning = OFF
- rear window heating = OFF

XX - Basic settings group XXX
activate default settings

fully depress - brake pedal + accelerator pedal

required values
field X = Syst. OK

upon achievement of values - continue

release - brake pedal + accelerator pedal

XX - Basic settings group XXX
activate default settings

fully depress - brake pedal + accelerator pedal

required values
field X = BX-SX OK

upon achievement of values - continue

release - brake pedal + accelerator pedal

XX - Basic settings group XXX
activate default settings

required values
field X = Syst. OK

upon achievement of values - continue

XX - Basic settings group XXX
activate default settings

fully depress - brake pedal + accelerator pedal

required values
field X = Syst. OK

upon achievement of values - continue

release - brake pedal + accelerator pedal

XX - Basic settings group XXX
activate default settings

required values
field X = TEV OK

upon achievement of values - continue

end

Log-in