Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
Engines / Petrol / MED 17.5.5 CAN general / Lambda-sensor downstream of catalyst - monitoring of ageing
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- exhaust system - tightness of line - OK
- engine speed = idling
- engine temperature > XX °C
- catalyst temperature >= XXX °C (XX - Measured values group XXX field X)
connect with the control unit XX - engine
XX - Measured values group XXX
required values field X (Lambda-sensor upstream of catalyst):
xxxxX = lambda control = active
xxxXx = lambda control = readiness for operation
xx?xx = heating of lambda probe(s)
if values are not achieved increase rpm to XXXX rpm
XX - Measured values group XXX
required values field X (Lambda-sensor downstream of catalyst):
xxxxX = lambda control = active
xxxXx = lambda control = readiness for operation
xx?xx = heating of lambda probe(s)
if values are not achieved increase rpm to XXXX rpm
XX - Basic settings group XXX
activate default settings
fully depress: brake pedal + accelerator pedal
required values
field X = RX-SX OK
if values are not achieved:
- do a test drive
- repeate this test
- replace - Lambda-sensor downstream of catalyst
- exhaust system - tightness of line - OK
- engine speed = idling
- engine temperature > XX °C
- catalyst temperature >= XXX °C (XX - Measured values group XXX field X)
connect with the control unit XX - engine
XX - Measured values group XXX
required values field X (Lambda-sensor upstream of catalyst):
xxxxX = lambda control = active
xxxXx = lambda control = readiness for operation
xx?xx = heating of lambda probe(s)
if values are not achieved increase rpm to XXXX rpm
XX - Measured values group XXX
required values field X (Lambda-sensor downstream of catalyst):
xxxxX = lambda control = active
xxxXx = lambda control = readiness for operation
xx?xx = heating of lambda probe(s)
if values are not achieved increase rpm to XXXX rpm
XX - Basic settings group XXX
activate default settings
fully depress: brake pedal + accelerator pedal
required values
field X = RX-SX OK
if values are not achieved:
- do a test drive
- repeate this test
- replace - Lambda-sensor downstream of catalyst
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.