Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
Engines / Petrol / MED 9.1 general / Test - knock sensor 1;2 - signal - test drive
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- knock sensor - tightening torque = XX Nm
- observe the occupation safety rules when taking a test drive with connected diagnostics tester
Start the engine - engine speed = idling
connect with the control unit XX - engine
do a test drive
Conditions:
- engine temperature > XX °C
- idling -> partial load -> full load -> deceleration
- full load = engine speed > XXXX rpm
XX - Measured values group XXX
observe values
field X = X,XV - X,XV (knock sensor X - voltage - cylinder X)
field X = X,XV - X,XV (knock sensor X - voltage - cylinder X)
field X = X,XV - X,XV (knock sensor X - voltage - cylinder X)
field X = X,XV - X,XV (knock sensor X - voltage - cylinder X)
desired condition: (field X = field X = field X = field X) ± X,XXV
XX - end of communication
upon non--achievement of condition - check component:
- knock sensor
- knock sensor - line
- knock sensor - tightening torque
- knock sensor - tightening torque = XX Nm
- observe the occupation safety rules when taking a test drive with connected diagnostics tester
Start the engine - engine speed = idling
connect with the control unit XX - engine
do a test drive
Conditions:
- engine temperature > XX °C
- idling -> partial load -> full load -> deceleration
- full load = engine speed > XXXX rpm
XX - Measured values group XXX
observe values
field X = X,XV - X,XV (knock sensor X - voltage - cylinder X)
field X = X,XV - X,XV (knock sensor X - voltage - cylinder X)
field X = X,XV - X,XV (knock sensor X - voltage - cylinder X)
field X = X,XV - X,XV (knock sensor X - voltage - cylinder X)
desired condition: (field X = field X = field X = field X) ± X,XXV
XX - end of communication
upon non--achievement of condition - check component:
- knock sensor
- knock sensor - line
- knock sensor - tightening torque
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.