Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
Engines / Petrol / MED 9.5.10 CAN general / Test - lambda control - Lambda-sensor downstream of catalyst 1 (AXW)
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- exhaust system - tightness of line = OK
- appliances = OFF
- engine speed = idling
- engine temperature > XX °C
- catalyst temperature > XXX °C
Start the engine
wait X minutes
connect with the control unit XX - engine
XX - Measured values group XXX
required values
field X = XXx (Lambda-sensor downstream of catalyst - status)
?xx = heating of lambda probe(s)
x?x = readiness for operation
xx? = lambda control
if values are not achieved - increase rpm to XXXX - XXXX rpm
wait
required values
field X = XXx (Lambda-sensor downstream of catalyst - status)
XX - Basic settings group XXX
activate default settings
depress and hold - brake pedal + accelerator pedal
required values
field X = -X.X - X.X V - fluctuates (voltage of lambda probe(s))
field X = XXXXXXX
if values are not achieved - field X - check component:
- field X =< - X,X V - Lambda sensor(s) - interruption or short-circuit to GND
- field X >= X,X V - Lambda sensor(s) - interruption or short-circuit to +XXV
upon achievement of values - continue
release - brake pedal + accelerator pedal
XX - Measured values group XXX
required values
field X = XxXXxxx
field X = xxxxXXX
- exhaust system - tightness of line = OK
- appliances = OFF
- engine speed = idling
- engine temperature > XX °C
- catalyst temperature > XXX °C
Start the engine
wait X minutes
connect with the control unit XX - engine
XX - Measured values group XXX
required values
field X = XXx (Lambda-sensor downstream of catalyst - status)
?xx = heating of lambda probe(s)
x?x = readiness for operation
xx? = lambda control
if values are not achieved - increase rpm to XXXX - XXXX rpm
wait
required values
field X = XXx (Lambda-sensor downstream of catalyst - status)
XX - Basic settings group XXX
activate default settings
depress and hold - brake pedal + accelerator pedal
required values
field X = -X.X - X.X V - fluctuates (voltage of lambda probe(s))
field X = XXXXXXX
if values are not achieved - field X - check component:
- field X =< - X,X V - Lambda sensor(s) - interruption or short-circuit to GND
- field X >= X,X V - Lambda sensor(s) - interruption or short-circuit to +XXV
upon achievement of values - continue
release - brake pedal + accelerator pedal
XX - Measured values group XXX
required values
field X = XxXXxxx
field X = xxxxXXX
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.