Engines / Petrol / SIMOS 10 UDS general / Test - filling pressure controller - Position sensor II (G581)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- engine speed = idling
- Error memory empty
- on-board voltage > XX.X V
- engine temperature MIN XX°C

connect with the control unit XX - engine

Advanced Measured Values

select item in menu:

IDEXXXXX-ENGXXXXXX - filling pressure controller - required value - position POSN_SN_BPA[X]

IDEXXXXX-ENGXXXXXX - filling pressure controller - required value PWM_BPA[X]

TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

required values - idling:

IDEXXXXX-ENGXXXXXX = IDEXXXXX-ENGXXXXXX
(+-X%)

if values are not achieved, check part:
- filling pressure controller - Position sensor
- filling pressure controller - Position sensor - wiring

Log-in Buy