Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
Engines / Petrol / SIMOS 3 general / adaptation - throttle valve
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
This operation was considered useful 4x.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- on-board voltage >XX V (XX - Measured values group XXX field X
- intake air temperature > X °C
- engine speed = X
Note:
- done after replacement of component: throttle valve, engine control unit
- done after repair of components: throttle valve, engine control unit
connect with the control unit XX - engine
Erasing of learning values
Note:
- if the adaptation values have already been deleted at this stage, then do not redo this adaptation value deletion process to prevent deletion of already adapted components
- if the adaptation values are now deleted, it is necessary to do basic setting (adaptation) of ALL subordinate actuators that require this, e.g. EGR, EVAP, throttle valve, etc.
XX - Adaptation channel XX
enter value XXX
Save
Basic settings
accelerator pedal - released !!!
XX - Basic settings group XXX
activate default settings
wait
required values
field X = ADP-OK
upon non--achievement of condition - check component:
- throttle valve
- line engine control unit -> throttle valve
XX - end of communication
switch ignition off for XX s
check of error memory
- on-board voltage >XX V (XX - Measured values group XXX field X
- intake air temperature > X °C
- engine speed = X
Note:
- done after replacement of component: throttle valve, engine control unit
- done after repair of components: throttle valve, engine control unit
connect with the control unit XX - engine
Erasing of learning values
Note:
- if the adaptation values have already been deleted at this stage, then do not redo this adaptation value deletion process to prevent deletion of already adapted components
- if the adaptation values are now deleted, it is necessary to do basic setting (adaptation) of ALL subordinate actuators that require this, e.g. EGR, EVAP, throttle valve, etc.
XX - Adaptation channel XX
enter value XXX
Save
Basic settings
accelerator pedal - released !!!
XX - Basic settings group XXX
activate default settings
wait
required values
field X = ADP-OK
upon non--achievement of condition - check component:
- throttle valve
- line engine control unit -> throttle valve
XX - end of communication
switch ignition off for XX s
check of error memory
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.