Engines / Petrol / SIMOS 7.1 general / creation of Readiness (229)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- engine temperature >= XX °C (XX - Measured values group XXX field X)
- catalyst temperature > XXX °C (XX - Measured values group XXX field X)
- parking brake = ON
- gear engaged (P) (automatic transmission)
- on-board voltage > XX V

Note:
- The readiness Code must be created as the last diagnostics task. Later deletion of the memory could also result in deletion of the created readiness Code.

delete error memory

Start the engine

wait XXX s

XX - Basic settings group XXX
activate default settings

wait XX s (follow the diagnostics instructions)

required values
field X = ADP-OK

upon achievement of values - continue

XX - Basic settings group XXX
activate default settings

required values
field X = Syst-OK

XX - Basic settings group XXX
activate default settings

wait

required values
field X = Syst-OK

XX - end of communication

Log-in Buy