Engines / UDS Engines by part number / 01 - Engine [EV_ECM12TFS02103F906070GL 004003] / Test of cruise control

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Part 1 of the order number Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- on-board voltage > XXV
- cruise control - activated

connect with the control unit XX - engine

Advanced Measured Values

select item in menu: IDEXXXXX-ENGXXXXXX - cruise control - position of switches CRU_SWI_POS_CAN

TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

required values:

XX = cruise control OFF
XX = cruise control ON
XX = pressed CANCEL
XX = pressed set
XX = pressed - RESUME

if values are not achieved - check component:
- cruise control
- wiring CAN-Bus
- cruise control - activated?

Log-in Buy